Zanussi 372023 EVO700 - 2 Frontal Zone Electric Induction Cooktop

Frontal 2-zone (5 kW each) electric induction cooking top with rear condiment holder (6x1/9GN)

Features: 

• Diameter of pots to be used: minimum 12cm to maximum 28cm to obtain maximum heating efficiency
• Suitable for countertop installation
• Glass ceramic cooking surface with 2 independently controlled induction zones with a power of 5 kW per zone
• Almost the entire surface of the ceramic plate can be used without "dead" spots
• Indicating lamp for each zone located on control console
• Induction plates endowed with overheating safety device
• Power to the individual zones can be set with progressive output i.e. fine regulation at the lower and larger progress at the upper levels
• Low heat dissipation to the kitchen
• IPX 4 water protection
• The smooth, glass ceramic plate is not directly heated, so there is no burning on cooking surface
• The well beneath the container support can be filled with ice to keep condiments cool and incorporates an overflow pipe for drainage
• One piece pressed 1.5mm work top in stainless steel
• Model has right-angled side edges to allow flush fitting joints between units, eliminating gaps and possible dirt traps
• Induction compatible pots & pans must be used.  

Key Information:  

Induction Top Dimensions (width): 800mm  

Induction Top Dimensions (depth): 700mm

Shipping Dimensions: 540mm H x 830 W x 850 D

Net weight: 57 kg  

All exterior panels in Stainless Steel with Scotch Brite finishing.  

Electric:  

Supply voltage: 380-415 V/3 ph/50/60 Hz  

Total Watts: 10 kW 

Predisposed for:  380-415V 3~ 50/60Hz 10kW 

Please note: If the appliance is set up on or next to or against temperature sensitive furniture or similar, a safety gap of approximately 150mm should be maintained or some form of heat insulation fitted.  

N.B Images are for illustrative purposes only. Specifications are subject to change without notice.